INVERTER COMPATIBILITY

Check your inverter model

A battery and inverter must be checked at model, firmware, protocol, cable pinout and current-limit level. Send the exact inverter model and firmware version so we can check the battery connection and settings.

Residential battery packs connected to electrical test equipment for configuration verification
Electrical testing supports configuration review; it does not establish universal inverter compatibility.

What we verify

Exact hardware

Battery model/BMS, inverter model, phase and battery-port requirements.

Communication

CAN or RS485 protocol, pinout, termination, DIP address and cable.

Operating limits

Charge/discharge current, voltage window, parallel quantity and firmware behavior.

Send these details for confirmation

  • Inverter brand, exact model and firmware version
  • Battery capacity and quantity
  • Single-phase or three-phase system
  • On-grid, backup, hybrid or off-grid application
  • Country and applicable certification
  • Photos of ports or existing wiring where relevant

Important: compatibility is configuration-specific and must be reconfirmed in the quotation or technical response.

Check before you order.

Send the exact inverter model and intended battery quantity.

Request compatibility check

What a compatibility confirmation should contain

  1. Exact inverter brand and model, region variant and firmware version.
  2. Battery model, BMS hardware/firmware and permitted number of parallel units.
  3. Supported voltage window, continuous current limits and operating mode.
  4. CAN or RS485 protocol selection, connector pinout and approved cable.
  5. Startup sequence, SOC reporting, alarm behaviour and controlled charge/discharge settings.

Physical connector versus working communication

Two devices can both have CAN connectors and still use incompatible messages or pinouts. Closed-loop operation requires the inverter to interpret the battery’s SOC and charge/discharge limits correctly. A connection that displays voltage alone is not proof that all protective and control functions have been validated.

Three review outcomes

Confirmed for the specified combination: retain the matching hardware, firmware and settings record. Further testing required: use sample evaluation before committing to volume. Not established: do not describe the combination as compatible or ship it on that assumption.

A public tested-brand matrix is not currently available here. Submit the exact inverter details for a model-specific review; the brand name alone is insufficient.

Commissioning evidence

  1. Battery and inverter recognise the intended protocol and battery count.
  2. Displayed SOC and operating limits are plausible and consistent.
  3. Charging and discharging remain within agreed limits.
  4. Alarms and recovery behave as required in the approved commissioning procedure.
  5. Settings, firmware and serial numbers are recorded for future support.